fender width recommendations

This section is for all posts concerning sheet metal fabrication
Post Reply
krymis
Conventioneer
Posts: 275
Joined: Sun Nov 06, 2011 12:46 pm
SELF INTRODUCTION: Hey dan it chris (krymis) from the CBH board. thanks for opening this back up. hope to have a project to show the build here. BLAH BLAH BLAH BLAH BLAH and so on and so forth. The book of revolations and worlds ends and shit like that.....

fender width recommendations

Post by krymis » Fri Apr 04, 2014 9:43 am

• 180-series tire recommended rim size is 5.50”, 5.50” rim size minimum and 6.00” rim size maximum; overall tire width is approximately 7.4” (187mm), tire diameter is approximately 25.8” (655mm) recommended fender width 8.5”
• 200-series tire recommended rim size is 5.5, overall tire width is 198mm/7.8″, tire diameter is approximately 679mm/26.7″, recommended fender width 9”
• 250-series tire recommended rim size is 9.00”, 8.50” rim size minimum and 9.50” rim size maximum; overall tire width is approximately 10” (252mm); tire diameter is approximately 25.9” (659mm), recommended fender width 11”
• 280-series tire recommended rim size is 10.00″, overall tire width is 277mm (10.90″), tire diameter is 25.79″, recommended fender width 12”
• 300-series tire recommended rim size is 10.5”, 10” rim size minimum and 11” rim size maximum; tire outside diameter is approximately 664mm (26.3”); tire outside width is approximately 327mm (11.8”), recommended fender width is 13”
• 330-series tire recommended rim size is 12”, 11.5” rim size minimum and 12.5” rim size maximum; tire outside diameter is approximately 25.0” (634mm), tire outside width is approximately 13.0” (330mm), recommended fender width is 14”
--Fender width recommendations are based on ½” fender side spacing allowing for internal struts and sidewall clearance. Not internally reinforcing the fender may allow you to go skinnier in fender width.

Post Reply

Return to “Sheet Metal Work”