hey all,
as part of rebuilding the crank on my knuck, i'm gonna need to true the flywheels. to get them in the ballpark, you need something to hold the flywheels as you bolt them together and begin to tighten them. i'm sure most of you have seen the kind of homemade clamps people use for this, but just in case someone isn't familiar with them, here's how you can make them.
you need 2 pieces of c-channel steel, a length of 1/2" threaded rod, and two 1/2" nuts. my c-channel is 125mm tall, 65mm wide, 6mm thick, and 130mm long.
to be continued…
-dan
Flywheel assembly clamp
- budoka
- Site Admin
- Posts: 492
- Joined: Thu Jul 21, 2011 12:51 pm
- SELF INTRODUCTION: I'm a Kentucky boy who's found himself transplanted into Japan. been into turning wrenches as long as i can remember. i love muscle cars, hotrod bikes, and the martial arts.
been a member of this board since back when it was a part of Chopperweb. been handling the tech side and sharing the admin duties for several years now. - Location: Fuefuki Shi, Japan
- Contact:
Flywheel assembly clamp
- Attachments
-
- tools_16023.jpg (57.63 KiB) Viewed 20627 times
-experience is a wonderful thing. It enables you to recognize a mistake when you make it again.
http://knuckleheadsummer.blogspot.com/
http://knuckleheadsummer.blogspot.com/