Page 1 of 1
ironhead frame
Posted: Thu Feb 05, 2015 1:05 pm
by krymis
Re: ironhead frame
Posted: Thu Feb 05, 2015 2:06 pm
by gww25
This turned out really nice, and I think, pretty darn original as well.
Re: ironhead frame
Posted: Fri Feb 06, 2015 8:08 am
by budoka
now THAT is sweet!
-dan
Re: ironhead frame
Posted: Sun Mar 08, 2015 4:35 pm
by outcast
Awesome.
Re: ironhead frame
Posted: Fri Apr 10, 2015 1:26 am
by railroad bob
That tubing arrangement on the rear section is unusual too me, looks really strong.
Re: ironhead frame
Posted: Fri Apr 10, 2015 9:51 am
by krymis
bob that setup is actually the weak setup. he should have ran the from the seat post back to the axle plate then added in the vertical tube. he has the top of the axle block and tube now pushing a short length of tubing horizontally into the vertical tube. it will work but i would have rather he did it another way.
Re: ironhead frame
Posted: Sat Apr 11, 2015 6:09 pm
by railroad bob
good point about the stresses from the axle plate going into the other tubing.
I took a second look, and you're right.